Single Pass Honing Tools (Through Bore)
Single Pass Honing tools for Through Bore is known as Abrasives that are coated on the cylindrical surface called the sleeve and these sleeves assembled on the Mandrels through which the material is removed and the desired size, geometry and surface finish are achieved. The hone process was developed to achieve the perfection in bore geometry, size control, surface finish and surface structuring.
The honing process provides the final sizing and creates the desired finish pattern on the inner bores. Finishing is accomplished by expanding abrasive stones or sleeves of suitable grit and grade against the working surface.
|a. Tool Range = Dia 5mm – 60mm|
|b. Suitable for Blind bores with or with out Undercuts|
|c. These are Electroplated Tools with Sleeve|
|d. The Sleeves can be coated with Diamond / CBN based on the requirement of honing components|
|e. These types of tools can even produce the required Hatch Pattern in the components|
|f. These types of tools has the guaranteed tool life which can achieve a very less cost per components with consistent results in the output|
|g. In These type of tools, the sleeves can be replaced for 2 to 3 Times, no need to buy a complete set which is again a cost reducing fact.|
|h. These types can be used for High production rate.|
Tell us how can we assist you?
We are always happy to answer any questions!
Just fill in the form and we will get back to you.